Lubricate thread and Cone / Nut and Ferrule
Process 10
- Assemble fitting until wrench - tight(without spanner extension)
- Mark position of nut
Process 8
- Tighten the Nut around 1 1/4 and 1 1/2 round (Note: Tube must not rotate)
Process 9
Assemble check:
- Loosen nut
- Check to make sure that a visible collar covers the front of the first cutting edge
- It does not matter if the ring can be rotated on the tube -end
Process 8
- Tighten the Nut around 1 1/4 and 1 1/2 round (Note: Tube must not rotate)
Process 10
- Assemble fitting until wrench - tight(without spanner extension)
- Mark position of nut
Process 11
- Then tighten fitting firmly by 30°(1/2flat)
- Recommended to use spanner extension for sizes over 20mm O.D (see chart)
Process 11
SPANNER LENGTH
| Size |
Spanner Length H (mm) |
| 22-L |
400 |
| 28-L 20-S |
500 |
| 35-L 25-S |
800 |
| 42-L 30-S |
1000 |
| 38-S |
1200 |
